1. Design your conveyor layout
Create and drag conveyors on the central canvas. Rotate, duplicate or delete from the right-click menu or Conveyor Settings.
💡 Right-click any conveyor to open its action menu. Left-click to select. Left-drag to move it.
2. Connect conveyors
Click Connect: ON. On the canvas, select an endpoint (A or B) on the sending conveyor, then an endpoint on the receiving conveyor.
Endpoints are directional. You can choose A → B, B → A, or another valid pairing to match your motor directions. Routing must be configured separately in Step 4.
Tip: Right-click a conveyor and choose “Connect from A” or “Connect from B” to begin faster.
3. Conveyor configuration
Select a conveyor on the canvas. Set length, width, speed, motor delays, rotation, single/multiple parcel mode and infeed status in the right panel.
Individual conveyor settings can be different for every belt. Right-click to duplicate, rotate or change parcel capacity.
4. Destinations
Add destinations, then select each conveyor to assign its movement direction and next conveyor for each destination.
Every destination can command a conveyor to move forward, reverse, or perform no operation. An EXIT completes the parcel.
5. Add parcels
Configure parcel dimensions and destination, then choose which infeed to release it from.
Parcel queue
6. Run simulation
Review your configuration, then start. Pause or resume from the same button. Reset to edit the layout and restore the original parcel queue.
Completed PPH uses simulated time: completed parcels × 3600 ÷ simulated seconds. Playback 10× does not inflate throughput.
Validate your layout before starting.